PT900 Bent Stamp-1/32" (0.75mm) Impression Height Leica 8mm hardened tool steel push

8mm hardened tool steel push pins

Built for the demands of the jewelry workshop

Developed in collaboration with Jay Whaley and Eurotool

One 5 lb box of Castaldo® Super High Strength™ Silicone Jewelry Molding Rubber strips

These holders rotate on the lower rack and can also be removed and placed around your bench for flexible

PT900 Bent Stamp-1/32" (0.75mm) Impression Height Leica 8mm hardened tool steel pushThis PT900 bent hallmark stamp is precision cut from heat treated tool steel and designed for marking precious metals with a clean, sunken impression. The bent shank also known as a gooseneck design makes it ideal for reaching the inside of rings and other curved or recessed surfaces where a straight stamp cannot reach. The impression height measures 1 32" (0. 75mm). Note that this measurement refers to the height of the impression, not the width.