Bus Fault Injection Board U100 1 A 2 AIn 4

1 A 2 AIn 4 (configurable: 0 … 10VDC

The Kvaser Leaf Light supports full speed USB interface for CAN with high performance at a low cost

Screw M3x6 Flat-head Phillips ISO 7045 A2 (5 pcs)

Each individual module can be networked via CANbus

1 Terminal block (2-pin) Switches 4 DIP switches Dimensions (L x W x H) 108 x 82 x 33 mm Weight 185 g Operating temperature -20 to 70 °C Enclosure Aluminum profile Protection IP20 Placement Table (adhesive pads included) DIN-rail mount (see Ordering Information)

Bus Fault Injection Board U100 1 A 2 AIn 4Allows the user to inject faults into a physical layer of a differential network The board can simulate errors: a wrong termination resistor, open shorted CAN_H or CAN_L to Gnd Vdd, disconnected Gnd or Vdd or Shield signal. The fault injector board is suitable for CAN, CAN FD, FlexRay, RS 485, and LIN buses. The Board has two sides left and right. There are two D SUB9F connectors wired 1: 1 at each side. The switches for fault injection are placed