Power Supply for M2/M3 M2 3D Printer Each bearing set is mounted

Each bearing set is mounted onto a separate idler bolt

Please note that rails and carriages are matched at the factory where they're produced

Travel Speed: 450 mm/sec maximum

it does have a limited lifespan

With these measurements

Power Supply for M2/M3 M2 3D Printer Each bearing set is mountedFeaturing a powder coated, stainless steel case with a current of 18. 8 A, this power supply provides a massive amount of power in order to heat your Heated Build Platform (HBP). Since November 2013 the MakerGear M2 has run on a 24 volt power supply, which includes an adjustment switch allowing for the use of both 100 130 V and 200 240 V wall power. If you ordered your M2 3D printer prior to November 2013, you will first need to install our "Power